Can your battery be topped up with water?
If it is the type that can be, there is one more thing you can do before deciding to replace it. About 5mL for each cell; for a standard 6-cell battery, that is 30mL in total.
We have released ORBITRON Battery Revive 30mL. This is a small-dose additive type, created by highly concentrating our professional-use Battery Restore PRO to match the size of batteries used in standard passenger vehicles.
It is exclusively for "open-type lead-acid batteries that can be topped up with water." It cannot be used for sealed types such as MF, AGM, EFB, or gel batteries. First, please check here to see if your battery is compatible.
View and purchase Battery Revive 30mL (3,850 yen including tax / domestic shipping only)
Things to check before deciding to replace
If you are worried about your battery, adding an additive shouldn't be your first instinct. First, check the type and the fluid level. If it is an open-type lead-acid battery where the fill caps can be opened and the fluid level managed, you can consider inspection and maintenance.
That is where Battery Revive comes in. Based on high-purity purified water, it is formulated with Asai Germanium (water-soluble organic germanium) specifically for lead-acid batteries. About 5mL per cell, totaling 30mL for 6 cells. Rather than measuring out an amount from a large bottle, we have packaged the exact amount needed for a standard passenger vehicle battery into one bottle.
Of course, this is not a product to fix a physically damaged battery. Results will vary depending on the charging state, internal deterioration, and operating environment.
What is the difference between Battery Revive and Battery Restore PRO?
Revive 30mL is a highly concentrated version of Restore PRO 1L. We do not disclose the concentration ratio or the blend percentages. The difference lies in the intended use case and the dosage.
- Battery Revive 30mL: Intended for compatible passenger vehicle batteries. Add approximately 5mL to each cell that has sufficient room for fluid. One bottle is enough for a standard 6-cell battery.
- Battery Restore PRO 1L: For professional sites managing multiple lead-acid batteries, such as trucks, commercial vehicles, and machinery. Replenish the necessary amount to cells where the fluid level has dropped.
Both can only be used on open-type lead-acid batteries that can be topped up with water. Simply adding 30mL of Restore PRO will not achieve the same result as using Revive. If you wish to replenish fluid levels or manage multiple units, please check out our commercial-use Battery Restore PRO.
Please check these 2 things before buying
- Is it an open-type that can be topped up with water? Check the markings on the battery or the instruction manual. Do not use on sealed-type batteries such as MF, AGM, EFB, or gel types.
- Is there enough room to add about 5mL to each cell? It cannot be used if the cell is already at the UPPER LEVEL (MAX) or if adding the fluid would exceed the maximum limit.
"It's a passenger car, so I can use it" is not the criteria. Please judge based on these two points: type and fluid level. If you suspect an internal fault, prioritize an inspection before adding any additives.
Instructions: approx. 5mL per cell
- Turn off the engine and confirm that it is an open-type lead-acid battery that can be topped up.
- Open the fill caps and check the fluid level of each cell. Use only if adding the fluid will not exceed the UPPER LEVEL.
- Add approximately 5mL of Battery Revive to each cell. A total of 30mL for 6 cells.
- Securely close the caps and use the vehicle as normal, or charge if necessary. Depending on the condition, multiple charge-discharge cycles may be required.
Do not drain the existing battery fluid. If the fluid level is low, replenish it to the correct level using commercially available purified water for batteries. Do not use if adding Revive would cause the level to exceed the maximum.
FAQ
Can it be used on any battery for a standard passenger car?
No. While the amount is tailored to the size of a standard 6-cell battery, it can only be used on open-type lead-acid batteries that can be topped up. It cannot be used on sealed batteries that cannot be topped up.
How many vehicles can one bottle service?
For a standard 6-cell battery, it is intended to service one unit using approximately 5mL per cell. Please check the fluid level of each cell to confirm if it can be used in your case.
Will a weak battery definitely be restored?
No. Internal damage, short circuits, or severe deterioration cannot be repaired. Results vary depending on the battery's condition and charging/usage circumstances.
If it's the type that can be topped up, consider it an option
When a battery needs to be replaced, it must be replaced. That fact does not change. However, if you have an open-type battery that can be topped up, there is room to inspect, check the fluid level, and try maintenance.
5mL per cell. 1 bottle for 6 cells. Battery Revive 30mL is 3,850 yen including tax. Shipping is available within Japan.
Check compatibility and precautions, and purchase Battery Revive 30mL
For professional-use topping up and managing multiple units, see Battery Restore PRO 1L. You can read the background in the Restore PRO launch article, and find details on on-site management in Lead-Acid Battery Maintenance for Trucks and Heavy Machinery.